Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Mael Eņin Tactical

Pages: [1]
Asset exchange / Re: WTB 500D Cordura Multicam and 1" multicam webbing
« on: November 01, 2019, 10:11:57 AM »
Depends where you are based

Europe = CLDistrubution
Everywhere Else = Brookwoods for cordura and texcel for webbing unless your after woven then WTF is your best option

Introductions / Re: Hello from the wilds of Scotland
« on: June 06, 2019, 10:56:16 AM »
hey based out by stirling nice to have another scot on board

Hey everyone, so while stitching part time i have also been at university studying electronic and electrical engineering, currently in my final year which means Honours Project dissertation woo.

For my dissertation i am designing and building a automatic cutting machine for webbing etc. The features as of writing this is as follows:
Automatic feeding of up to 5" wide material/materials
steady Temperature controlled Hot knife cutting
user selectable cutting temperature
Accurate Cutting to specified lengths (currently increments of 5mm)
Quantity of cuts to 9999
Easy user interface
Cut from user provided file ( see Below)

as well as the above the aim is to make it as small and also as cheap as possible without jeopardizing function or durability.

The final features is to allow the user to create a simple file that has all the cuts for a product place it on a USB, insert into the machine and be able to cut the lengths on the file to the quantity inputted on the machine. this was with a product with multiple lengths in mind like a chest rig to make setting up a production run of cutting simpler and as the files will be incredible tiny

i was wondering if there is any features you guys like or would like in an automatic cutter or any considerations to take into account, If any of you are interested in the progress i can keep you all updated.

Thanks in advance for any input

Introductions / Hi from Sunny Scotland
« on: June 21, 2017, 01:13:11 PM »
Hey Gearmakers, I have been sewing going on 3 years now. It has been a very comfortable part time job while doing a degree in electrical engineering but now that i am finishing up,  it's full steam ahead with making Mael Eņin Tactical my full time job.

I have been visiting this form for a good while and appreciate the knowledge everyone shares and i hope to share some of my knowledge with this community also.

Sitch Bitch

Pages: [1]